Bypasses

[b-1]

Has the ability to bypass the +/- limit switches been removed from the rule section in 2.23? I see that I can select soft +/- limits and e +/- limits, but not the physical switches.

Come to think of it, it isn't listed in the override section in the Axis Status Details panel either.........

[Nate]

B1,
I believe you are experiencing the difference between an axis Modbus, which is the process that runs on the D series, and F series winches and axis controllers, and the axis I/O process. In the axis I/O process, you have complete control over bypassing your limits from the axis panel and the rules, but with the axis Modbus, you can only bypass your soft limits and encoder limits. - N

[b-1]

Thanks,

Didn't know that.